Add:No.: 6,Yingtong industrial road,Shalang industrial area,China
Tel:+86 (760)89980693
ventilation fans

High pressure centrifugal ventilation fans

Structure of 4-79, 4-2 × 79 High pressure centrifugal ventilation fan.
The fan is mainly composed of impeller, casing, air inlet and motor. In addition to the above-mentioned parts, No7C ～ 20E also has a transmission part. 1. Impeller: It consists of backward inclined arc thin blade, curved front disc and flat back disc. They are all made of steel plates and corrected for static and dynamic balance. The air performance is good, the efficiency is high, and the operation is stable. 2. Case: made into two different types. No3 ～ 12 case is made as a whole and cannot be disassembled. The casings of No14 ～ 20 are made into two-open type, except that they are divided into two halves along the mid-level horizontal plane and connected with bolts. 3. Air inlet: It is made as a whole and installed on the side of the fan. The cross section parallel to the axial direction is a curved shape, which allows the gas to enter the impeller smoothly and the loss is small. 4. Transmission group: composed of main shaft, bearing box, rolling bearing, pulley or coupling.

Category:

Description

High pressure centrifugal ventilation fans
4-79, 4-2 × 79  ventilation fan, It’s for indoor ventilation, and ventilation of general factories and large buildings. It can be as input gas or output gas. By the way, the type of gas to be transported is air and other gases that do not ignite spontaneously, do not explode, have no entanglement, are harmless to the human body, and are not corrosive to steel materials. Don’t allow viscous substances in the gas, and the dust and hard particles contained in it are not more than 150 mg / m3. Gas temperature: no more than 80 °C. Those with similar gas properties can also be used.

Types of ventilation fans  1. Each fan casing is made in two types: clockwise rotation and counterclockwise rotation. 2, The outlet position of the fan is expressed by the outlet angle of the casing. Model 4－79 fans, No3A ～ 6A are made into a type when they leave the factory.

The unit re-installed to the required position according to the requirements. Can adjust the position of the air outlet from 0 °C to 225 °C,  and the interval is 45 °C; No7C ～ 8C output.  The position of the air outlet can be adjusted from 0 °C to 180 °C with an interval of 22.5 °C,  No10E ～ 20E single inlet and double inlet outlet positions are made into three fixed sizes: 0 °C,  90 °C  and 180 °C, which cannot be adjusted. If you need non-standard models such as special machine numbers and special air outlet angles. Our company can design and manufacture them for you, but you need to specify in detail when confirming the order.

Related products